Frankenglock on the Rack – Again

As I’ve related before, my Gen2 Glock 17 Bruce has had just about all its internal parts replaced. It’s about 20 years old, and it still shoots great.

At the GSSF match last September, the Armorers told me of an issue they were aware of with the older, Gen2 frames, where they were prone to develop cracks just behind the locking block. The good news, they told me, was that if I would take it by the factory in Smyrna, they would be happy to do some work to the frame that would prevent the cracking.

So, yesterday, I had some free time, and made my way to Highlands Drive in Smyrna. After signing in, I went to a waiting room, where I was met by an Armorer who knew just what I was talking about.

After about 30 minutes, he came back with my frame, which was cut thus, and the plastic rail relieved some ahead of the cut.

Like a dummy, I didn’t think to take a “Before” picture, but here is a picture I found online for comparison:

Of course. in the process, the Armorer also replaced all the internal parts, so Frankenglock is all set for another 20 years or so, till I pass it down.

Starbucks Appreciation Day 2

As reported by Sebastian and others, the National Gun Victims Control Action Council is holding another boycott of Starbucks, on February 14, because of their policy of allowing customers to follow whatever local laws say about the open carry of guns in their stores.

As a result, Sebastian is proposing a second annual Starbucks Appreciation Day on the same day. I plan to visit my local Starbucks with my wife, and thank the manager for their refusal to yield to the anti-gunners.

I encourage you to do so, too, and report your impressions here.

Holster Review – Don Hume H715-M IWB

Once upon a time, when I carried my Glock 17 inside the waistband, I used a cheap, non-branded split leather holster, that I bought for $4 at a big box sporting goods store while my wife was next door buying throw pillows.

I didn’t carry my G17 inside my pants very often. It was painful after just a short while carrying. The back of the slide dug in, and the extended magazine release, which wasn’t covered by the holster, pinched my skin whenever I moved.

A few years later I got a smaller Glock 19, and it was a little better to carry than the G17 with this holster, but not much.

+++++

Then, a couple of years ago, I was on a business trip in the Dallas/Ft. Worth area, and I had an extra hour before I needed to be back at the airport for my flight, so I dropped by Cheaper Than Dirt. (Actually, I made my flight plans with a trip to Cheaper Than Dirt in mind.)

I had never given much thought to a leather IWB holster, but there on the Don Hume wall was a great looking little number for the G19, priced at $22. I decided to give it a try, and I’m glad I did.

The holster fit is just right. I use “just right” on purpose. Leather holsters are fit to the gun they hold, and not all of them are done well. For instance, I have one holster with a fit that looks really great, so that the outside of the holster looks just like my gun. But, it is fit so tight to the ejection port that the leather has been cut by the trailing edge of the ejection port by the repeated action of holstering and drawing my gun.

On the Don Hume, the interior of the holster is shaped to the G19 just enough to hold the gun in place. Retention is excellent, while the draw is smooth, with no hesitation or hold up.

Coverage of the gun is excellent as well. The trigger and trigger guard are completely covered, and the barrel doesn’t extend past the end of the holster at all.

The holster rides higher on my pants than the old one did, and at first, I didn’t like that. The difference isn’t much – the Don Hume rides at about the trigger, and the old holster rode at the magazine release – but after some practice, I find that I can draw my gun a lot easier with more of the gun elevated.

The problem I had with the magazine release pinching into my skin is solved in this holster. While the mag release isn’t covered, the holster material is thicker than the length of the release, so that it does’t even reach my skin.

The top of the holster is reinforced, so that the holster is held open while it is in place in my belt, even with the gun removed. As a test, I’ve carried the holster empty for several hours, and the holster never collapsed. re-holstering is smooth.

The leather finish is excellent, without blemishes or streaking. The belt clip is just right, too, and holds on to my 1-1/2 inch belt without slipping off, yet isn’t too stiff that I can”t easily remove it with my thumb.

+++++

Based on two years of using it at least 4 times a week, I can enthusiastically recommend the Don Hume H715M holster for the Glock 19.

The next time business takes me to Fort Worth, I’ll probably pick one up for my G21.

Justice At Long Last?

As soon as I felt your gun I should have took two steps back, pulled my Glock 40 and just put 10 bullets in your ass and let you drop. And I wouldn’t have lost any sleep.

Canton, Ohio Patrolman Daniel Harless

Daniel Harless, whose embarrassing and inexcusable treatment of motorist and concealed carry license holder William Bartlett during an incident in the early morning hours of June 8, 2010, has finally been fired as the result of the investigation by his department.

There’s not really a whole lot I can add to this story. The whole thing was caught on the police dashboard camera, and the Ohioans for Concealed Carry (OFCC) made sure it was posted on Youtube.

The judge hearing Bartlett’s case eventually through out all charges against him. Harless’s hearing was then delayed several times because of the stress Harless was undergoing, caused in no small part, no doubt, by the publication of videos of other incidents he was involved in.

Here is the dash camera footage, with commentary by the OFCC. I should note that the video contains some language that Harless uses that may be shocking to some.


Video (c) 2011 Ohioans for Concealed Carry

Kudos to the OFCC for their work on this!